System Information

Navigation bar > > Settings > Wi-Fi

This allows to set the Wi-Fi service, it is described in the table below

Parameter

Description

Enable Wi-Fi

 Activation/deactivation of the Wi-Fi service.

Wi-Fi mode

The parameter allows the user to decide the Wi-Fi mode by selecting one of the two available otpions:

Option

Function

Wi-Fi LAN (station)

 The EMS connects to an existing Wi-Fi network as a client (such as a company or home router).

Wi-Fi 1-to-1 (access point)

 The EMS acts as a Wi-Fi access point, broadcasting its own SSID and enabling other devices to connect to it.

The Wi-Fi parameters strictly depend on the Wi-Fi mode selection, described on the following sections:

The device connects to an existing Wi-Fi network (such as a company or home router).

By clicking the available Wi-Fi networks will be shown in the Available connection tab.

By selecting one of the available connection, the system requires to enter the password to connect to the network.

As the alternative solution, the user can enable the Manual mode to enter the W-Fi network settings manually.

the device acts as a Wi-Fi access point, broadcasting its own SSID. The user connects directly to this network using a PC or mobile device. Once connected, the login page can be accessed via a predefined IP address (default 172.0.0.1) through a standard web browser. The table below describes all the available parameter for this Wi-Fi mode:

Parameter

Description

SSID*

 Service set identifier, it is the name of the Wi-Fi network

Encription

The user is required to select one of the following options:

WPA

WPA2

WPA_2

Password

It allows to set the password to access the Wi-Fi (max. 25 characters).
Enable advance mode

If enabled, it allows the user to set the following parameters;

Parameter

Function

Channel

 select the number of the channels, from 1 (default) to 11.

Bandwith

 Select between 20 MHz or 40 MHz
IP address* IP address value.
Netmask* Network mask address value (default value 255.255.255.0).

Note: parameters followed by * are mandatory. Clicking you can either save () or reset () the configuration.